Wireless Microphone - LOTRONIC ibiza sound MOV8-CD Manuel D'utilisation

14) DC INPUT CONNECTOR: Used to plug the DC 15V mains adaptor.
15) POWER LED: The LED will illuminate when the power is switched On.
16) LOW LED: The LED will illuminate when the voltage of the built-in DC 12V BATTERY is lower than 10.5V.
17) BAT.FUL LED: The LED will illuminate in green when DC 12V BATTERY is fully charged. The LED will illuminate in
red when DC 12V BATTERY is lower. Please charge the power when The LOW LED is illuminated.
18) WIRELESS MICROPHONE LED: The LED will illuminate when you turn on wireless microphone.
19) AUX OUTPUT: Connect the mixer to a second active box or amplifier powering speakers.
CD Player
20) CD POWER: Control the unit's main power.
21) MODE: Selection function of the CD/USB/SD/Bluetooth.
22) REPEAT: Selection of repeat mode REPEAT 1, REPEAT FOLDER, REPEAT ALL, REPEAT OFF.
23) FOLDER PREV/NEXT (PITCH): USB/CD mode allows searching the information from previous and next folder.
When under CD mode, press FOLDER PREV/NEXT key to control the speed of PITCH between +5 and -5.
24) SHUFFLE/ENTER: Random broadcast and confirm function.
25) MUTE: Press this button no audio output.
26) PREV/NEXT: select the previous track and next track.
27) PROGRAM: when press this button, and then press FOLDER PREV/NEXT key to select the music, press ENTER to
confirm. Up to 20 tracks can be programmed and played repeatedly. Press PLAY to start listening to your program.
28) EJECT: You can now safely eject the CD
29) PLAY/PAUSE/STOP: Short press to play and pause; Long press to stop.
30) VOLUME/SETUP: Press the SETUP key to select EQ mode FLAT-CLASSIC-ROCK-JAZZ-BASS
31) Infrared receiver
32) USB/SD: Insert USB/SD device here.
33) LCD: Display with CD/MP3's status information.

WIRELESS MICROPHONE

• Open the battery compartment on the microphone via a screwdriver. Insert a 1.5V battery (included) with the
correct polarity into the battery compartment. Close the battery compartment and tighten the screws.
• Slide the switch ("ON/OFF") upwards to the ON position, the LED below the switch should light and the LED on the
main unit should also light to indicate that carrier signals are being received.
• If the "LOW – BATT" LED on the microphone lights, change the battery.
• Avoid "feedback" (howling or screaming sound through the speaker) by keeping the microphone at a sensible
distance from the speaker and pointing it away from the speaker so that it doesn't hear its own output.
• When not in use, switch the wireless microphone off. If you will not use the microphone for an extended period of
time, remove the battery.
Specifications
Input Sensitivity/ Impedance:
MIC 1-2 ............................................................................................................... 3.0mV/ 600 Ohms
AUX IN ............................................................................................................... 300 mV/27K Ohms
Output power RMS/max. ....................................................................................75/150W/4 Ohms
Frequency Response ........................................................................................ 20Hz-20kHz +/-2 dB
S/N Ratio (@ 1 kHz):
MIC .................................................................................................................. ＞80 dB/ 3mV input
Line .............................................................................................................. ＞90 dB/ 300mV input
Distortion:
MIC ........................................................................................................................................... 0.5%
Line ........................................................................................................................................... 0.3%
©Copyright LOTRONIC 2016 MOV8-CD 5