Samsung BD-F7500 Mode D'emploi page 31

Wireless Network
You can setup a wireless network connection in
four ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
- WPS(PIN)
When you configure the wireless network
connection, any wireless network devices currently
connected through the player or, if applicable,
the player's current wired connection, will be
disconnected.
Wireless - Automatic
Ğ
1. In the Home screen, select Settings, and
then press the v button.
2. Select Network, and then press the v
button.
3. Select Network Settings, and then press the
v button.
4. Select Wireless in the Network Settings
screen, and then press the v button. The
player searches for and then displays a list of
the available networks.
Network Settings
Select your network type.
Network type Wireless
Wireless network
linksys3
solugen_edu#2
iptime23
solugen_edu#1
Refresh WPS(PBC)
All manuals and user guides at all-guides.com
5.
6.
| NOTES |
\ To view the password as you enter it, use the arrow
7.
8.
| NOTES |
\ You should be able to find the Security Code or Pass
Ğ
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
1.
2.
You can connect your Blu-ray
player to the internet. Please
select which wireless network to
3.
use.
4.
5.
Select the desired network, and then press
the v button.
On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with an arrow button, and
then pressing v button.
buttons to select Show Password on the right side, and
then press v button.
When done, select Done and then press the
v button. The player verifies the network
connection and then connects to the
network.
When verification is complete, select OK, and
then press the v button.
Phrase on one of the set up screens you used to set up
your router or modem.
Wireless - Manual
Follow the directions in Wireless - Automatic
through Step 5.
The player searches for a network, and then
displays the connection failed message.
On the bottom of the screen, select IP
Settings, and then press the v button.
The IP Settings screen appears.
Select the IP Setting field, and then press the
v button.
Select Enter manually in the IP Setting field,
and then press the v button.
31
|
English