Publicité
Les langues disponibles
Les langues disponibles
DOWNDRAFT OPERATION
Downdraft Operation
CONTROL MODULE
To activate the downdraft, press the UP/DOWN button.
1
The downdraft chimney will elevate and the blower will
turn on automatically to low speed. Refer to the illustra-
tion below.
To adjust the blower speed, press the HIGH+, MEDIUM
2
or LOW button. The corresponding LED will illuminate to
indicate blower setting.
To initiate boost mode, press and hold the HIGH+ button
3
for 5 seconds. Boost increases airflow by approximately
20% more than high, but is limited to 10 minutes. After
10 minutes, the blower will automatically transition to
high.
To deactivate the blower, press the button that corre-
4
sponds with the illuminated LED indicator or press
UP/DOWN.
DELAY FEATURE
The delay feature continues blower operation for approxi-
mately five minutes after use, then automatically turns off.
If the blower was operating on high or medium speed,
the blower will transition to the next lowest setting for five
minutes before turning off. The chimney will stay up until the
UP/DOWN button is pressed.
Control module.
All manuals and user guides at all-guides.com
FILTER INDICATOR
After approximately 30 hours of operation, the FILTER LED
will illuminate to indicate filters need to be cleaned. Refer to
care recommendations on page 9.
To reset the filter indicator, press the FILTER button. Refer to
the illustration below.
|
wolfappliance.com
7
Publicité
