Publicité
POWER SUPPLY
IMPORTANT!
• Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst.
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Batteries contain chemical substances, so
they should be disposed of properly.
Using AC Power
1. Check if the AC power supply, as shown on the
type plate located on the bottom of the set,
corresponds to your local power supply. If it does
not, consult your dealer or service centre.
2. Connect the mains lead to the wall socket.
3. To disconnect the mains supply, unplug the set
from the wall socket.
The type plate is located on the bottom of the
set.
This set complies with the radio interference
requirements of the European Community.
For users in the U.K., please follow the boxed
instructions 'Important notes...' on this sheet.
BASIC FUNCTIONS
Switching on and off and selecting function
1. To switch on, adjust the POWER slider to select:
CD, RADIO or TAPE function, and operate the
respective function controls.
2. To switch off, adjust the POWER slider to select
TAPE/OFF and make sure all the
cassette keys are released.
Note : The DBB setting, tuner presets and the
volume will be retained in the set's memory.
Adjusting volume and sound (See 2)
1. Press the VOLUME 3 or 4 controls to adjust the
volume.
2. Press DBB once or more to select dynamic bass
boost on or off.
DIGITAL TUNER
Tuning to radio stations
1. Adjust the POWER slider to RADIO.
™ tu is displayed briefly and then the radio
station frequency, waveband and, if pro-
grammed, a preset number are shown. (See 3)
2. Press BAND once or more to select your wave-
band.
3. Press and hold SEARCH ∞ or § until the
frequency in the display starts running.
™ The radio automatically tunes to a station of
sufficient reception. Display shows Srch
during automatic tuning.
4. Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press ∞ or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception:
• For FM , extend, incline and turn the telescopic
aerial. Reduce its length if the signal is too strong.
• For MW (AM or LW) , the set uses a built-in aerial.
Direct this aerial by turning the whole set.
Programming radio stations
You can store up to a total of 40 radio stations in the
memory, manually or automatically (Autostore).
Manual programming
1. Tune to your desired station (see Tuning to radio
stations).
2. Press PROGRAM to activate programming.
™ Display: Pr -- and PROG flashes.
3. Use the digit panel on the set to key in a number,
1-40, to select a preset station. E.g. press 1,1 if
you want to store your station as preset 11. (See
4)
• Remote control (AZ1505 models only): Press
-
+
PRESET
/
once or more to select a preset
station.
4. Press PROGRAM to confirm.
5. Repeat steps 1-4 to store other stations.
Note : You can erase a preset station by storing
another frequency in its place.
DIGITAL TUNER
Publicité
