Publicité
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
No sound /power
- Volume not adjusted
• Adjust the VOLUME
- Mains lead not securely connected
• Connect the AC mains lead properly
- Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
- Headphones connected to the set
• Disconnect headphones
Severe radio hum or noise
- Electrical interference: set too close to TV, VCR or
computer
• Move the set to increase the distance
Poor radio reception
- Weak radio signal
• FM: Adjust the FM telescopic aerial
noPr indication
- During programming radio preset stations, you have
keyed in a preset number that exceeds the maximum
preset number i.e. 40
• Key in a preset number from 1-40
noCd indication
- CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
- Laser lens steamed up
• Wait until lens has cleared
nFCd indication
- CD-R(W) is blank/ not finalized
• Use a finalized CD-R(W)
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
dAtA indication
- CD contains non-audio files
• Press SEARCH ∞ or § once or more to skip to a
CD audio track, instead of the data file
The CD skips tracks
- CD damaged or dirty
• Replace or clean CD
- SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Poor cassette sound quality
- Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
- Use of incompatible cassette types (METAL or
CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
- Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space
Remote control does not function properly (for
AZ1505 model only)
- Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
- Distance/ angle between the set too large
• Reduce the distance/ angle
Publicité
