Publicité
MODEL
RATING BTU/H
FUEL CONSUMPTION
ELECTRICAL INPUT
MANIFOLD PRESSURE
UNPACKING
1. Remove the heater from the carton.
2. Remove all packing materials applied to the heater for shipment.
3. Remove all items from the carton.
4. Check the heater for shipping damage. If heater is damaged, promptly inform PowerFast Products Group at (423) 837-5155.
INSPECTION AND PREPARATION
1. Check the heater for possible shipping damage. If there is visible damage or a missing part, immediately contact PowerFast
Products Group for assistance at (423) 837-5155.
2. Inspect the hose assembly prior to using the heater. If there is evidence there is excessive abrasion or wear, or the hose is cut,
replace the hose prior to operating the heater.
3. DO NOT CONNECT THE POWER CORD TO AN OUTLET UNTIL YOU HAVE FINISHED THE PREPARATION.
4. Connect the POL fitting of hose and regulator assembly to the propane cylinder by rotating the POL nut counterclockwise
into the propane cylinder's valve outlet and securely tighten with a wrench.
5. Connect the hose to the heater by rotating the hose fitting clockwise.
6. Securely tighten all gas connections with a wrench.
7. Open the cylinder's gas valve and check all gas connections with a soap and water solution. DO NOT USE A FLAME. If
bubbles appear, there is a leak. Tighten all of the connections and retest for leaks.
8. Unloosen the adjustment knob, set the heater to the desired height, and tighten the knob.
Supply Valve
Regulator
Hose
CONNECTING TO THE POWER SOURCE
Connect the power cord to a 3-prong, grounded extension cord adequately rated for this application.
Extension Cord Wire Requirements:
• 6 to 10 feet (1.8 to 3 meters) long, use 18 AWG conductor.
• 11 to 100 feet (3.4 to 30.5 meters) long, use 16 AWG conductor.
• 101 to 200 feet (30.8 to 61 meters) long, use 14 AWG conductor.
WARNING: Never leave the heater unattended while operating.
WARNING: Never leave the heater unattended while operating.
Disconnect the heater from its power source when not in use.
Disconnect the heater from its power source when not in use.
All manuals and user guides at all-guides.com
SPECIFICATIONS
R45LP
45k
2.1 lb/h
1.8/2.3/2.8 lb/h
120V/60Hz/0.5A
120V/60Hz/0.5A
11" W.C.
OPERATING INSTRUCTIONS
Propane Tank
-6-
R60LP
R125LP
40-50-60k
90-110-125k
4.4/5.1/5.8 lb/h
120V/60Hz/1.03A
11" W.C.
8.7" W.C.
-6-
R160LP
120-135-155k
5.5/6.2/7.2 lb/h
120V/60Hz/1.03A
6.2" W.C.
Inlet
Connector
Hose
LIGHTIN
1. The
2. Allow
3. Slow
4. Depr
5. After
comb
6. If the
7. Turn
SHUTDO
1. Tight
2. Allow
3. Turn
4. Disco
5. Disco
6. Allow
RESTART
1. Secu
2. Disco
3. Rest
STORAG
1. Inspe
servi
2. Inspe
hose
the P
using
3. Turn
4. Store
NFPA
Chap
Gas
SERVICIN
At least a
modified f
Publicité
