Publicité
Les langues disponibles
Les langues disponibles
HEATING MODE
The heating function allows the air conditioner to heat the room.
●To activate the heating function ( HEAT ) , press the MODE button
until the symbol
appears on the display.
●With the button
or
higher that of the room.
In HEATING operation, the appliance can automatically activate a defrost cycle, which is essential to
clean the frost on the condenser so as to recover its heat exchange function. This procedure usually
lasts for 2-10 minutes.
During defrosting, the unit fan stop operation. After defrosting, it resumes to HEATING mode
automatically.
-In this mode, you may have to wait for a few minutes before the appliance starts giving out hot air.
-In this mode, the fan may operate for short periods, even though the set temperature has already
been reached.
●Water is removed from the air and collected in the tank.
●When the tank is full, the appliance shuts down and "
tank cap must be extracted and emptied. Run off all water left into a basin. When all the water has
been drained, put the cap back in place.
●When the tank has been emptied, the appliance starts up again.
DRY MODE
This function reduces the humidity of the air to make the room
more comfortable.
●To set the DRY mode , Press MODE until
An automatic function of pre-setting is activated.
●In this mode, fan speed is selected automatically by the appliance and
cannot be set manually.
In dry mode, the appliance should be prepared in the same way
as for cool mode, with the air exhaust hose attached to enable the
moisture to be discharged outside.
FAN MODE(Not FAN button)
Fan mode, air ventilation only.
● To set the FAN mode, press MODE until
When using the appliance in this mode, the air hose does not
need to be attached.
TCL Air Conditioner Service Manual
set a temperature 13℃-27℃(55℉-81℉)
appears in the display.
appears on the display.
"(full tank) appears on the display. The
23
Publicité
