Publicité
Les langues disponibles
Les langues disponibles
Installing an expansion card
1.
Remove the metal cover opposite the
slot that you intend to use.
3.
Insert the card connector to the slot��
then press the card firmly until it fits in
place.
4.
Replace the metal bracket lock.
Installing storage drives
Optical drive
1.
Place the chassis upri�ht�� then remove the upper 5.25" drive bay metal plate cover.
2.
Insert the optical drive to the bay�� then carefully push the drive until its screw holes
ali�n with the holes on the bay.
3.
Secure the optical drive with two screws on both sides of the bay.
4.
Connect the I�� (4A) and power (4B) plu�s to connectors at the back of the drive.
3
Floppy disk drive
If the system comes without a portable hard disk (optional), then you may install a floppy disk
drive into the 3.5-inch drive bay.
1.
Place the chassis upri�ht�� then remove the upper 3.5" drive bay metal plate cover.
2.
Insert the floppy disk drive to the bay, then carefully push the drive until its screw holes
ali�n with the holes on the bay.
3.
Secure the floppy disk drive with two screws on both sides of the bay.
4.
Connect the si�nal (4A) and power (4B) plu�s to connectors at the back of the drive.
3
a4�67_V7-P5G43M_qs�.indb 7
All manuals and user guides at all-guides.com
1
2
2
Installation manual
2.
Remove the metal bracket lock.
2
4
3
3
3
4B
4A
4B
4A
��4�0� 3:24:05 PM
Publicité
