Publicité
HOW TO MAKE CUSTOM SIZED BAGS
1. Pull enough bag material to hold item to be vacuum packaged, plus 3 inches. With a pair of scissors, cut desired
bag length from Bag Roll. Make sure to cut in a straight line. Plug in Power Cord.
2. Open the Lid. Place one end of cut bag between Sealing Strip
and Lower Sealing Gasket. DO NOT place open end of bag
in the Drip Tray.
3. Close Lid. Position hands on both sides of the Lid. Press firmly
on both sides of the Lid and hold until the motor starts.
NOTE: Sealer will not operate if Lid is not properly closed,
or if open end of bag is placed in the Drip Tray.
4. Continue to hold the Lid. When the Hands-Free
Indicator Light illuminates, it is safe to remove your
hands from the Lid. The unit will continue to vacuum
and then starts sealing. The Sealing Indicator Light
illuminates when the unit begins sealing the bag.
5. When the motor stops and the Sealing Indicator Light
is no longer illuminated, press the Open/Cancel button.
6. The custom sized bag is ready for vacuum sealing.
NOTE: The Open/Cancel button can also be used to cancel the process mid-cycle and open the Lid. The bag will not
be sealed when doing this.
CAUTION: Make sure you give the appliance time to cool down. Wait at least 20 seconds between seals.
Under very heavy usage, appliance will shut off automatically to prevent overheating. If it does so, wait
20 minutes to allow appliance to cool off.
All manuals and user guides at all-guides.com
Hands-Free Indicator Light
Publicité
