Télécharger Imprimer la page

Brink Pure induct Manuel D'opération page 5

Publicité

Reinigen/vervangen filters
Het onderhoud van de Pure induct is beperkt tot het periodiek vervangen van het filter.
Het filter van de Pure induct wordt tegelijk vervangen met de filters van het WTW toestel.
Het filter hoeft pas te worden vervangen indien dit wordt aangegeven op het display van het WTW toestel (hierop ver-
schijnt filtersymbool
of, indien een standenschakelaar met filterindicatie is geplaatst en rode led bij deze schakelaar
brandt.
Ieder jaar dienen de filters vervangen te worden.
Het Pure induct toestel mag nooit zonder filter worden gebruikt.
Schoonmaken c.q. vervangen van de filters:
Pure induct: Na losnemen twee sluitingen kan deksel worden verwijdert en het filter worden uitgenomen en
vervangen.
Let op: Pijl op het filter moet corresponderen met pijl op het Pure induct toestel!
WTW-toestel: Druk langer dan 3 seconden op het filter symbool
Volg nu de instructies die op het display verschijnen om filter te reinigen c.q. te vervangen.
Deze filterwizard kan niet worden afgebroken.
Wanneer alle instructies op menu zijn afgewerkt en bevestigd, dan wordt de filterwizard afgesloten door op
"Home" toets
te drukken en komt het display terug op hoofdscherm; de timer van filtermelding is gerest en de
filtermelding is nu verdwenen.
Cleaning filter
The maintenance on the Pure induct is limited to the periodic replacement of the filter.
The filter of the Pure induct is simultaneously replaced with the filters of the HRV device.
The filter only has to be replaced if this is indicated on the display (the filter symbol is shown here)
multiple switch with filter indication has been installed and the red LED of the switch is on.
The filters should be replaced each year.
The Pure induct must never be used without filter.
Cleaning and replacing the filters:
Pure induct: After removing two closures, the lid can be removed and the filter can be taken out and replaced.
Note: Arrow on the filter must correspond with arrow on the Pure induct device!
HRV device: Press the filter symbol
Now follow the instructions that appear on the display to clean and/or replace the filter.
This filter wizard cannot be interrupted.
When all the instructions on the menu have been followed and confirmed, then the filter wizard is closed by
pressing the "Home" button
the filter message now disappears.
Art.-nr.: 616451-B
All manuals and user guides at all-guides.com
Onderhoud
Maintenance
for longer than 3 seconds to open the filter wizard.
and the display then returns to the main screen; the filter message is reset and
Pure induct
om filterwizard te openen.
NL
GB
or, if a
5

Publicité

loading