Parts And Components - Newteck WIND PURE Mode D'emploi

• A lways fill the water tank with clean water. If it is full, do not tilt (or knock) the unit.
• T he appliance must not be used by children or any person with reduced physical, sensory or
mental abilities, or with a lack of experience or knowledge, unless they are being supervised by
a responsible person whilst operating the unit.
• P lease turn off the power before pulling out the mains plug. Do not pull on the power cable, pull
the plug itself to avoid breakages, short circuits, fires or electric shocks.
• D o not handle the plug with wet hands, as this may cause an electric shock.
• P lease disconnect the mains plug when not using the device.

PARTS AND COMPONENTS

OPERATION
Control panel:
• SWING: Oscillation/Movement
• OFF: Stop/Shut-down
• LOW: Low speed
• MID: Medium speed
• HIGH: High speed
• COOLING: Cold/Cooling
How to use the unit:
1. To activate the air conditioner, press the button for the desired speed (low-mid-high) and it will
change to the correct position
2. I f you want to activate the oscillation function to vary the direction of air flow, press Swing
3. To turn off the unit and stop the air flow, press the OFF button and it will automatically reset its
position .
Cooling Function (humidification):
1. R emove the water tank from the back of the air conditioner and fill the tank with clean water. The
water level must be between the "MIN" and "MAX".
12
.
.