Uline H-88 Mode D'emploi

π
H-88
INDUSTRIAL HANDWRAPPER
LOADING FILM ONTO HANDWRAPPER
NOTE: Handwrapper comes preset at 12" height.
Must unthread completely to use larger rolls.
1. Unscrew the top knob (turn counterclockwise) about
1/2". Remove the slotted top core holder by sliding it
out of the threaded rod section.
2. Slide the film roll over the top knob and position the
film core over the bottom core holder.
3. Take the top core holder and slide it back through
the threaded rod section. Drop it into the top of the
core.
4. Screw the top knob clockwise until it holds the top
core holder in place.
PAGE 1 OF 3
Top Knob
Threaded Rod Section
INSTRUCTIONS
1-800-295-5510
uline.com
Knob Assembly
(Washer, Bearing,
Threaded Rod)
Top Core Holder
Bottom Core Holder
REMOVING FILM FROM HANDWRAPPER
1. Unscrew the top knob (turn counterclockwise) about
1/2". Remove the slotted top core holder by sliding it
out of the threaded rod section.
2. Remove the film by sliding it over the top knob.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0323 IH-88