Publicité
Les langues disponibles
Les langues disponibles
Measurement and instrumentation
Multimeter model UT60A
Réf :
291 033
ENGLISH
All manuals and user guides at all-guides.com
6.2 Setting of RS232C Serial Ports
Default of RS232C serial port for communication is set as:
Baud Rate
2400
Start bit
0 (always 0)
Stop bit
1 (always 1)
Data bits
8
Parity
1 (Odd)
6.3 System Requirements for Installing the UT60A
Interface Program
To use UT60A Interface Program, you need the following hardware and
software:
•
An IBM PC or equivalent computer with 80486 or higher processor
and 640 x 480 pixel or better monitor
•
Microsoft Windows 95 or above
•
At least 8MB of RAM
•
At least 8MB free space in hard drive
•
Can access to a local or a network CD-ROM
•
A free serial port
•
A mouse or other pointing device supported by Windows
7 Maintenance
Warning
Do not attempt to repair or service your multimeter unless you are
qualified to do so and have the relevant calibration, performance test,
and service information. To avoid electrical shock or damage to the
Multimeter, do not get water inside the case.
7.1 General Service
•
Periodically wipe the case with a damp cloth and mild detergent. Do
not use abrasives or sol vents.
•
To clean the terminals with cotton bar with detergent as dirt or
moisture in the terminals can affect readings. Press the POWER to
turn off the multimeter when it is not in use and take out the battery
when not using for a long time.
•
Do not store the Multimeter in a place of humidity, high temperature
and strong magnetic field.
7.2 Testing the Fuses
Warning
To avoid electrical shock or personal injury, remove the test leads and
any input signais before replacing the battery or fuse.
To prevent da mage or injury, install ONLY replacement fuses with
identical amperage, voltage, and speed ratings.
30
Publicité
