Ariston BCZ M 400 IX Mode D'emploi page 20

function will be deactivated automatically (the LED
GB
switches off); the food may now be moved into the
two lower compartments (so that the Cool Care Zone
can be used if necessary) or even left in the Cool
Care Zone compartment, which operates as a normal
storage compartment when the function has not
been activated.
• Do not re-freeze food that is defrosting or that has already
been defrosted. These foods must be cooked and eaten
(within 24 hours).
• Fresh food that needs to be frozen must not come into
contact with food that has already been defrosted.
• Do not place glass bottles which contain liquids, and
which are corked or hermetically sealed in the freezer
because they could break.
• The maximum quantity of food that may be frozen daily is
indicated on the plate containing the technical properties
located on the bottom left side of the refrigerator
compartment (for example: Kg/24h: 4).
• In order to obtain a greater amount of space in the
freezer compartment, you may remove the bins
(except the lowest bin and the special COOL CARE
ZONE bin, which has an adjustable temperature) and
place the food directly onto the evaporator plates.
! Do not open the door during freezing.
! If there is a power cut or malfunction, do not open the
freezer door. This will help maintain the temperature inside
the freezer, ensuring that foods are conserved for at least
9 -14 hours.
The Cool Care Zone is a special compartment in the
freezer which allows the user to choose between 4
different operating modes that may be set according to
specific requirements and the type of food stored
inside. The temperature settings that may be selected
are -8°C, -12°C and -18°C, indicated by the icons
depicting a strawberry, an ice cream and a bottle on
the control panel. The Cool Care Zone is equipped with
controls that may be operated independently from the
other compartments inside the freezer, by the Cool
Care Zone may also be deactivated using the control
panel, so that it can then be used as a normal freezer
compartment.
20
All manuals and user guides at all-guides.com
The fact that they are situated on the top part of the
freezer drawers ensures greater cleanliness: the ice no
longer comes into contact with the food placed inside
the freezer compartment; furthermore, the dripping of
the water during filling is avoided (a lid to cover up the
hole after filling with water is also provided).
1. Pull out the tray by pushing it up.
Check that the tray is ompletely empty and fill it with
water through the opening provided.
2. Take care not to exceed the level indicated (MAX
WATER LEVEL). Excess water prevents the ice cubes
from dispensing (if this happens, wait for the ice to
melt and empty the tray).
3. Turn the tray 90°: due to the connected
compartments each mould fills with water ( see
diagram ).
4. Close the opening with the lid provided and put the
tray back, placing the top part in the corresponding
housing and allowing it to drop in again.
5. When the ice has formed (minimum time
approximately 8 hours) knock the tray against a hard
surface and wet the outside so that the ice cubes
come loose and take them out through the opening.
MAX
WATER LEVEL