Free-Standing Installation (Model Sbc678Os); Keg Installation; Caster Guide - Summit SBC677BI Manuel Du Propriétaire

Fontaine à bière en fût
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

This model may be installed as a free-standing unit (see clearance dimensions
below). However, for built-in installation, you must provide the following clearances
around the unit for best operation and proper ventilation: 3/16" on both sides, 2" at the
rear and 1/16" at the top. Take care that the air vent at the front of the keg beer
dispenser is never covered or blocked in any way.

Free-standing Installation (Model SBC678OS)

For freestanding installation, 5 inches (127mm) of space at the back and sides of the
unit are suggested, which allows the proper air circulation to cool the compressor and
condenser for energy saving. Air vents should never be blocked.

Keg Installation

Caster Guide

(for use as a freestanding or outdoor beer dispenser)
NOTE: Only model SBC678OS is supplied with casters.
• Install the four casters (2 locking casters at front) into the unit's bottom (four screw
holes pre-supplied). Figure 1: before installation. Figure 2: casters installed.
CASTERS
7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Sbc678os

Table des Matières