Table des Matières
Publicité
PRO.BOSE.COM
EX-1280
Front Panel
Power/Status indicator: This LED illuminates white when the processor is powered on. The LED may blink
q
white or change colors while the system is booting up. If the LED illuminates and remains red after the
bootup is complete, please see Maintenance > Troubleshooting (page 26).
OLED Display: This display provides metering and network information and settings. See Operation
w
(page 20) for more information.
Rotary/Press Knob: Turn and press this knob to navigate menus. See Operation (page 20) for more
e
information.
Rear Panel
q
w
Analog audio inputs: 12 balanced audio inputs (3.81 mm, 6-pin Euroblock), routable to automatic echo
q
cancellation (AEC) using ControlSpace Designer software. See Installation > 3. Analog Audio Connections
(page 16) for more information.
Analog audio outputs: 8 balanced audio outputs (3.81 mm, 6-pin Euroblock). See Installation >
w
3. Analog Audio Connections (page 16) for more information.
Control Inputs: 5 inputs for general-purpose control (3.81 mm, 6-pin Euroblock). See Installation >
e
7. Control Connections > GPIO > General-purpose Inputs (page 18) for more information.
Control Outputs: 5 outputs for general-purpose control (3.81 mm, 6-pin Euroblock). See Installation >
r
7. Control Connections > GPIO > General-purpose Outputs (page 18) for more information.
Dante ports: 2 Ethernet ports for connection of Dante digital audio devices. See Installation >
t
5. Dante Network Connection (page 17) for more information.
Micro-B USB port: Connect this port to a computer for use with soft codecs with stereo input and output.
y
See Installation > 6. Far-end Connections > Soft Codecs (page 17) for more information.
USB port: Not currently supported. Available for future updates to ControlSpace EX-1280.
u
AmpLink Out port: RJ-45 connection for use with AmpLink-equipped amplifiers. See Installation >
i
4. AmpLink Connection (page 16) for more information.
Serial port: 3-wire RS-232C (DTE) connection (3.81 mm, 3-pin Euroblock) to serial control interface. See
o
Installation > 7. Control Connections > Serial (page 19) for more information.
CC-16 port: 3-wire RS-485 connection (3.81 mm, 3-pin Euroblock) to Bose CC-16 zone controller or other
a
control interfaces. See Installation > 7. Control Connections > CC-16 (page 19) for more information.
Power input: Power cord connection to AC mains power (IEC 60320-C14 inlet). See Installation >
s
8. Power Connection (page 19) for more information.
Installation & Operation Guide • EX-440C/1280/1280C/12AEC
q
w e
q
r
q
t
y
u
i
Overview
w
e
o
a
s
English • 11
Publicité
Table des Matières
