Bose Acoustimass II 16 Serie Notice D'utilisation page 10

S U
ETTING P
Figure 8
Acoustimass ® module to
receiver connections
Checking and finalizing connections
Optional upgrade for your Acoustimass 15 system
10
Get user manuals: See SafeManuals.com
Thumbscrews
®
Acoustimass
module
Before plugging in the Acoustimass module, check all connections from the receiver to the
the module and the module to the small speakers (Figure 5 on page 8 and Figure 8).
• Make sure all cube speaker arrays are connected to the proper terminals according to their
position in your room.
• Check to be sure all wires are connected to your surround receiver with the proper polarity
(+ to + and – to – wires). Incorrect wiring can result in a total loss of module output.
• Correct any wiring problems before you plug in your receiver and turn it on.
When all the connections check out, plug the power cord from the Acoustimass module into
an AC (mains) outlet. Plug in the receiver also.
Note: Bose recommends using a quality surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components in any system. Using a high-
quality suppressor (available at electronics stores) can eliminate the vast majority of failures
caused by a power surge.
Your Acoustimass 15 Series III speaker system can be upgraded to provide you with 6.1- !
or 6-channel surround sound.
The 6.1 upgrade kit contains one cube speaker array, a 50-foot (15.2 m) connecting cable,
and complete connection instructions.
To purchase the 6.1 upgrade kit in the same color as your current system, contact your local
retailer. Or to contact Bose directly, see the address list included in the !
authorized Bose ®
carton.
When ordering, you will need to provide the serial number of your Acoustimass module. !
Refer to "For your records" on page 2 if you recorded the number there. If not, you can locate
the number on the rear of the module near the connection panel.
Français
16
Español
Home theater
LFE connector with
receiver
cover removed
English