Kalorik HVC 39365 Mode D'emploi page 6

All manuals and user guides at all-guides.com
Fax +1 305 430 9692
When the battery's lifetime is over and it does not charge up
•
anymore, please send the appliance to the authorized service
center of the manufacturer for replacement. Do not replace the
battery yourself.
USING YOUR VACUUM CLEANER
Once your appliance is fully charged, remove it from base,
•
holding it by its handle.
Switch it on by pressing the ON/OFF switch.
•
Tilt the vacuum cleaner till the nozzle of the dust container is
•
placed horizontally on the surface that is to be cleaned.
When you are finished, press the ON/OFF switch again, to switch
•
off the appliance, before putting it back into the charging base.
Practical hint: underneath the charging base you can find a storage
compartment, where you can store the accessories supplied
(crevice tool, round brush) safely and without risk of misplacing or
losing them.
USING THE ACCESSORIES
Using the crevice tool:
Insert the larger round end of the
•
crevice tool into the nozzle of the
dust container.
Use it to clean in narrow, hard-to-
•
reach places, such as heater gaps,
wall ends and corners, etc.
You can also use this crevice tool to
•
avoid scratching the nozzle of the dust container.
Using the round brush:
First, insert the larger round end of the
•
crevice tool into the nozzle of the dust
container, as explained above.
Then insert the square end of the round
•
brush onto the crevice tool.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
6
Assembly page 6/32
Team
Print only
HVC 39365 - 120501