Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1.
Switch on the sound source (TV, PC, VCR, DVD player or audio component) that
the transmitter is connected to.
2.
Place the headphones On/Off switch in the On position.
3.
Before placing headphones on head, make sure the volume is not too loud and then
place the headphones on your head and adjust the volume to obtain the desired
sound level.
4.
There are 3 available channels. Press the Auto Scan button on the headphones to
search for the best reception. The corresponding indicator light will illuminate.
NOTE:
You should then be able to move freely from one room to another with no interference. If
interference does occur (interruptions in the signal), press the Auto Scan button once to
find a better reception channel.
A
For better stereo reception, stay approximately 23 feet away from the transmitter
when you press Auto Scan.
B
If it is impossible to find a satisfactory frequency, change the channel setting
(CHANNEL 3 2 1) on your transmitter, then press Auto Scan to find the
corresponding channel.
To protect the transmitter and save power, the transmitter will automatically switch off after
approximately four minutes if the signal from the audio source is too weak. If, however, the
signal returns to an acceptable level, the transmitter automatically switches back on.
ATTENTION:
The transmitter for this wireless stereo headphone set is designed to work with a wide
variety of devices. Our tests have shown the default volume levels of iPods, MP3 players
and other devices connected to the transmitter through the headphone jack does not have
the signal strength required by the transmitter. Raising the volume of your device will
increase the signal strength to the transmitter. The red signal LED will light when the
required signal strength from your device if reached. We recommend that you keep the
volume set on your iPod or MP3 player at a minimum of ¾ of full volume.
All manuals and user guides at all-guides.com
6
TECHNICAL SPECIFICATIONS
Transmission mode
: UHF stereo
Carrier frequency
: 900Mhz
Operating voltage
: Transmitter – 12V 200 mA
Receiver – 2.4 V (two rechargeable batteries, LR03/AAA size)
Frequency response
: 50 Hz – 12 KHz
Distortion
: 1%
Signal-to-noise ratio
: 72 dB
Channel separation
: 50 dB
Range
: 150 feet max.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
7
the
Publicité
