Publicité
Les langues disponibles
Les langues disponibles
Before Using the Headphone System
An initial 24-hour charge is required to ensure an acceptable service life for the
rechargeable batteries. Always ensure that the headphones are switched to the Off
position while the batteries are charging.
INSTALLATION
RECEIVER HEADPHONES
1.
Open the cover of the rechargeable battery compartment located on the side of the
right-hand receiver headphone.
2.
Insert two rechargeable LR03/AAA size batteries taking care to ensure correct
polarity.
3.
Close the battery compartment cover.
TRANSMITTER
1.
Connect the provided AC/DC power to an electrical outlet.
2.
Connect the AC/DC power adapter cable to the DC IN input connector located on
the transmitter rear panel.
3.
Plug in the AUDIO IN cable located on the back of the transmitter panel to a
headphones/earphones output on your TV, stereo system, VCR, PC, or radio.
Depending on the size of the Audio Out port of your audio component, you may need
to use the included Jack Plug Adapter. If the stereo (or other audio component) has a
two-hole Audio Out (left and right) connection, use the RCA socket audio adapter
provided. Connect it to the end of the AUDIO IN cable and then to the Audio Out
connection on the component making sure to match the RED to RED and the WHITE
to WHITE.
4.
A cable is provided from the transmitter rear panel that can be connected to the audio
output (left and right) on a TV, stereo system, VCR or radio, or to a
headphones/earphones output using the connector supplied.
" Note: You may need the included iPhone Adapter to connect your iPhone to the
transmitter for audio streaming. Simply plug the cable from the transmitter into one
end of this iPhone Adapter, then plug the other end of the adapter into your
iPhone. "
All manuals and user guides at all-guides.com
4
The red operating indicator will light up as soon as you have connected the power adapter
to the outlet and the audio cable to a signal source. If the operating indicator light remains
off, switch on the audio source and increase its output volume level until the red indicator
light comes on.
CHARGING THE BATTERIES
1.
Place the On/Off switch on the receiver headphones in the Off position.
2.
Place the headphones on the transmitter, taking care to ensure that the charge
contacts touch the transmitter's charge prongs.
3.
The charge process starts automatically and the green indicator light comes on. Be
sure to charge new batteries for 24 hours before using them for the first time in the
headphones.
WARNING:
Never attempt to recharge conventional dry cells.
Never use another type of battery or non-rechargeable batteries to replace the
rechargeable (LR03/AAA) batteries supplied. When the headphones are not in use, move
the switch to the OFF position to avoid damaging the batteries. The batteries must always
be fully charged before use.
IMPORTANT:
When replacing the batteries or disposing of the unit, always comply with applicable laws
relating to the disposal of batteries. Please place them in a proper disposal container to
ensure that they are eliminated safely and in an environmentally friendly way.
5
Publicité
