Publicité
Les langues disponibles
Les langues disponibles
Applying Wax or Polish (Continued)
3. Place the orbital polisher against the work surface before turning it on. Use long horizontal and vertical
strokes to apply the wax or polish and let the polisher do the work. Do not push down on the polisher or
it will not work efficiently.
4. For tight spaces or areas around wheels, emblems, antennas, etc, apply the wax by hand (you may
remove the bonnet and use it for this task).
Removing Wax or Polish
Removal:
After the entire surface has been covered with the wax or polish, let it dry to a haze before removal:
1. Remove the terrycloth applicator bonnet from the orbital polisher.
2. Using a paper towel or clean cloth, wipe off any excess wax or polish that remains on the foam buffing
wheel after removing the applicator bonnet.
3. Install the soft buffing bonnet using the same Bonnet Installation procedures listed on page 10.
4. To remove wax or polish, use the same long horizontal and vertical strokes used during application.
5. Again, let the tool do the work and do not push down on the polisher. Note that, as with applying the wax
or polish, hard to reach places should have the material removed by hand with a soft buffing bonnet or a
microfiber towel.
6. The result should be a nice even mirror-like shine.
OPERATION
11
Publicité
