poolstar formidra Guide D'installation & D'utilisation page 5

1 USE
ST
Once the shower is connected to water, Open the tap (hot water) in order to release the air contai-
ned in the shower and to allow the tank of the shower to fill completely.
When the water starts to drop from the head of the shower, this means that the tank of the solar
shower is full. At that point you can turn off the shower tap and wait for the water inside the tank
to be heated. Cold water is immediately available.
USE
When the water is heated by the sun in summer, a little quantity of water may drop from the head
of the shower. This is normal, because the volume of the water inside the shower increases due
to the heat.
The shower and the foot washer can be used separately or simultaneously. Only the shower can
provide a mix of hot and cold water. The other elements provide only cold water.
In case of continuous use, you will see a drop in the temperature of water, being the duration of
the sunlight insufficient.
MAINTENANCE AND WINTER
After a prolonged use, it is possible that limestone and other deposits form on the head of the
shower. Turn off the water supply in order to remover the shower head to clean it.
The solar shower is designed to be used under conditions of an external temperature above
15 °C.
At the end of the season of use, close the water supply. In the areas where the external tempe-
rature drops below 3 °C, make sure to drain the tank, in order to avoid damages caused by frost.
EN
It is advisable to put your shower in the shelter or to protect it with a protective cover available
as an option, outside periods of use.
WARRANTY
POOLSTAR warrants to the original end user customer or purchaser that the product is free from
defects in material and workmanship for a period of two (2) years. This warranty does not cover
damages caused by frost.
For further information, please visit our website at
http://assistance.poolstar.fr
5