Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting Guide
If you have a problem, please follow this guide. You may also want to visit our Web site at: www.desatech.com. For
more help call 1-800-858-8501 8:00 AM to 4:30 PM Central Time weekdays.
Lo sentimos, pero no podemos contestar preguntas en español por teléfono.
SYMPTOM
POSSIBLE CAUSE
1. Light switch is turned off.
Lights will
2. Flood light is loose or burned out.
not come
3. Fuse is blown or circuit breaker is
on.
turned off.
4. Daylight turnoff is in effect. (Re-
check after dark) .
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
Lights
1. Control may be installed in a rela-
come on in
tively dark location.
daylight.
2. Control is in Test. (Set control
switch to an ON-TIME position) .
1. Control may be sensing small ani-
Lights come
mals or automobile traffic. (Re-
on for no
aim sensor or use lens shield) .
apparent
2. Sensitivity is set too high. (Reduce
reason.
sensitivity. Turn Range Boost off) .
598-1007-02
SYMPTOM
Lights stay on
continuously.
Lights flash
on and off.
-13-
Get other manuals https://www.bkmanuals.com
POSSIBLE CAUSE
1. A lamp is positioned too close to the
sensor or pointed at objects that causes
the sensor to trigger. (Aim the lamp
away from the sensor or objects) .
2. Control is pointed at a heat source like
an air vent, dryer vent, or brightly-painted
heat-reflective surface. (Re-aim sen-
sor. Turn Boost off).
1. Heat or light from the lamps may be
turning the Light Control on and off.
(Aim lamps away from the sensor. Turn
Boost off).
2. Reflected heat from other objects are
triggering the sensor. ( Re-aim sensor.
Turn Boost off).
3. Control is in warming up. (Flashing is
normal under these conditions. Wait 1
minute for sensor to warm up).
4. Control is in Test. (Set control switch to
an ON-TIME position).
Publicité
