Xtrem Bots ELITE TROOPER Mode D'emploi page 6

3. BATTERIES INSTALLATION
IN THE TRANSMITTER
1. Use a philips' head screw to open the battery compartment lid of controller.
2. Put 2 x 1.5V "AA" batteries inside the battery compartment.
3. Put the lid back and use a screw to tighten the lid.
IN THE ROBOT
Robot battery is into the back of the Elite Trooper.
To charge battery, please insert the USB port provided USB charging cable to anyone USB port of a
computer, a power pack, a mobile charger or a car USB charger.
Switch OFF the robot before charging. A light in the robot will be turned on during the charging
process; when the robot is fully charged the light will turn off.
The charging time is about 2 hours and the playing time is about 2 hours.
4. START THE ELITE TROOPER
Switch on the ON/OFF button on the back of the Elite Trooper
and push the "StandBy" button to start the Elite Trooper. The
Elite Trooper introduce himself performing some movements and
sounds.
NOTE: The robot should stay on the floor.
6