Ermax Speedmax SP0101109 Notice De Montage page 4

3. Dismount the top cover of the scooter beginning by the meter side (screw removed previously), then remove the
down (see under photo for the location of the lower clips).
4. Unscrew the 4 screws which maintain the original windshield. The screws location is shown on the under photo.
- Place the short fitting square between the mirror and the original raiser. Place the square as shown on the schema of
st
the 1 page.
- Place the fitting bars.
- Position the 4 holed cylinders on the 2 fitting bars.
- At the 4 fixing points of the windshield, slip on as shown on photo and schema of the 1
washer, then one rubber washer, the windshield and one other rubber washer.
- Screw the windshield on holed cylinders and tighten screws when the windshield is well positioned regarding the
light.
Fixing being provided for « universal » mounting, positioning adjustments
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
are necessary.
« CAUTION »
st page : one screw in one Ø6