Haws 30-WKOH Mode D'emploi page 28

30-WKOH
HOUSEHOLD USE ONLY
PARTS DESCRIPTION
1. Lid
2. Handle
3. Water gauge
4. On/off switch and indicator light
5. Power base
6. Water inlet
7. Filter
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
1. Pour out left over water from previous boiling cycle and fill with the desired amount of fresh water to the
water kettle. Make water directly run through the water inlet at the center of the lid (the strong water
flow can push the cover of the water inlet to open automatically), or open the lid and fill with the desired
amount of water to the water kettle. Always fill the kettle between the minimum (0.5L) and maximum
(1.7L) marks.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
2. Connect the plug into a power outlet. Press the switch downwards. The indicator will light up. Then start
to boil the water. The kettle will switch off automatically once the water has boiled. You can shut off the
power by pressing the switch upwards at any moment during boiling water.
NOTE: Ensure that switch is clear off obstructions and the lid is firmly closed all the time throughout the
boiling cycle. The kettle will not turn off if the switch is constrained and scalding may occur if the lid is
open.
3. Once the water boils, wait 10 seconds before pouring out water to prevent hot steam from exiting through
the lid of the kettle. Lift the kettle then pour the water.
NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.
4. The kettle will not re-boil until the switch is pressed again. Allow to cool for 30~40 seconds before
reopening to boil water. Never re-boil water older than 2 hours.
NOTE: Ensure power supply is turned off when kettle is not in use.
5. Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this occurs, allow the kettle to cool before filling with cold water and
re-boiling.
CLEANING AND MAINTENANCE
1. Always let the kettle cool down first and disconnect the appliance from the power outlet before cleaning.
2. Never immerse the kettle area or cord in water, or allow moisture to contact with these parts.
3.
To clean the filter: open the lid and take out the filter, have the filter rinsed under running water and then dry it.
Place it back correctly.
Cleaning appearance of housing:
Wipe the appearance of body with a mild and damp cloth or cleaner, never use a poisonous cleaner.
Never immerse the power base in water or other liquid for cleaning.
- 27 -
EN