AirLive WL-5470POE Guide De Démarrage Rapide page 7

Installation Steps
1. Please install your network cards first
2. Screw-in the antenna (clockwise) into the Antenna connector
3. Connect the power and LAN cable to the back
4. Use your wireless card to do a site survey. The default SSID is airlive, and the default Channel is 11.
5. If you need to change AP's configuration, please follow the procedure below:
■ The AP's default IP address is 192.168.100.252. Please
make sure your computer IP is in the same subnet as the AP (i.e. 192.168.100.x)
■ Open the web browser and enter http://192.168.100.252/.
Wireless Mode Setup
This page includes all primary and major parameters for the wireless mode setting. Any parameter change
will cause the device to reboot for the new setting to take effect.
Wireless Modes: AP, Client, Bridge, WDS Repeater, Universal Repeater, WISP(Client Router)
and WISP + Universal Repeater mode and Gateway (AP Router) mode
The default mode is set to AP. You can change it to another mode.
Network Type: When in Client mode, you can select between Ad-Hoc or Infrastructure.
All manuals and user guides at all-guides.com
WL-5470POE
English
5