Keysight U2761A Mode D'emploi page 94

2 Features and Functions
Trigger Input Signal
Trigger in
Figure 2-29
The device connector is used for Triggered Sweep Mode, refer to
Source"
on the Trig In connector, the U2761A outputs a single sweep, refer to
Triggering"
Trigger Output Signal
A "trigger out" signal is provided on the device Trig Out connector (used with
sweep only). When enabled, a TTL-compatible Square waveform with either a
rising (default) or falling edge is output to the device Trig Out connector at the
beginning of the sweep.
Trigger out
Figure 2-30
When the Internal (immediate) trigger source is selected, the U2761A outputs a
Square waveform with a 50% duty cycle to the Trig Out connector at the
beginning of the sweep. The period of the Square waveform is equal to the
specified sweep time.
94
Trigger input pulse
on page 89. When the rising or falling edge of the TTL pulse is received
on page 93.
Trigger output pulse
Rising edge shown
> 500 s
Rising edge shown
Keysight U2761A User's Guide
"Sweep Trigger
"External