Keysight U2761A Mode D'emploi page 91

Triggering
Applies to sweep only. You can issue triggers for sweeps using Internal
(immediate) triggering, External triggering, or Manual (software) triggering.
– Internal triggering is enabled when you turn on the U2761A. In this mode, the
– External triggering uses the device Trig In connector to control the sweep. The
– Manual triggering initiates one sweep each time you click Trigger
Trigger Source Choices
You must specify the source from which the U2761A accepts a trigger.
– The sweep trigger source consists of Internal, External, or Manual. The default
– The U2761A accepts a Manual trigger, a hardware trigger from the device Trig
– The trigger source setting is stored in volatile memory where the source is set
Soft Front Panel Operation
On the Trigger Setup panel as shown in
source from the drop down list
Remote Interface Operation
Keysight U2761A User's Guide
U2761A outputs continuously when the sweep mode is selected.
U2761A initiates one sweep each time Trig In receives a TTL pulse. You can
select whether the U2761A is triggered on the rising or falling edge of the
External trigger signal.
soft front panel.
trigger source is Internal.
In connector, or continuously output sweeps using an Internal trigger. At
power-on, Internal trigger is selected.
to Internal (immediate) trigger upon power-off or after a remote interface
reset.
TRIGger:SOURce {IMMediate|EXTernal|BUS}
Features and Functions
Figure 2-28, select the desired trigger
at the Source panel.
2
on the
91