Publicité
Les langues disponibles
Les langues disponibles
USE AS A MINI-CHOPPER
As a mini-chopper, the appliance is intended
to chop meat, cheese, onions, garlic, herbs,
carrots, nuts without shells, etc.
Do not attempt to chop very hard food such as
nutmeg, coffee beans, cereal and ice cubes.
Stems and seeds must be removed from fruit
and vegetables, and meat must be boned,
trimmed and cut into small cubes of 1-2 cm
before mincing.
1.
Attach the blade (10) inside the chopping
beaker (11).
2.
Fill the chopping beaker with food.
3.
Attach the attachment (9) to the motor
section (4) so that it clicks into place.
Attach the attachment (9) to the chopping
beaker (11).
4.
Plug the appliance into the mains.
5.
Hold the chopping beaker firmly with one
hand. Press the on/off I button (2) to start
the appliance at low adjustable speed. If
necessary turn the speed selector (1) to
adjust the speed. You can also press the
on/off II button (3) to start the appliance
at the highest speed. If you use this on/off
button, the speed selector's setting is not
important, as the appliance runs on the
highest possible speed. Keep the button
pressed for as long as you are chopping.
6.
Release the on/off button (2/3), and allow
the appliance to stop completely before
removing the attachment (9) from the
chopping beaker (11).
NOTE!
•
Do not leave the appliance running non-
stop for more than 60 seconds at a time.
Then leave it to cool for at least 1 minute.
UK
CLEANING
•
Always clean the appliance immediately
after use.
•
Unless clearly specified in the cleaning in-
structions below, please note that none of
the parts of this appliance are dishwasher
safe.
•
Always switch the appliance off at the wall
socket and unplug before cleaning.
•
Clean the motor unit and attachments (6,
7, 9) by wiping them with a damp cloth.
These parts must not be immersed in
water and make sure no water enters the
appliance. The blade on the stick mixer at-
tachment (6) can be rinsed under running
water.
•
All other parts can be washed up in soapy
water. All parts must be completely dry
before the appliance is assembled and
used again.
•
Be careful not to touch the blades during
cleaning!
•
Never use abrasive detergents or sol-
vents.
25
Publicité
