GE Lumination IS Serie Guide D'installation page 6

Pull out continuous wiring
6
Pull the continuous wiring out of the luminaire being mounted and slide the bridge of the luminaire down onto the bridge of the
already installed luminaire so that the tabs and slots at top and bottom nest into one another. The bridges will engage with a
loud click when fully mated.
7
Connect the power and control
connectors of the through wiring
harness.
10
Replace the PSU cover(s) and secure
using the mounting screws.
Note: When installation is complete,
all lead wires and connectors shall be
totally enclosed.
Align tabs
with slots
8
At the beginning of the row, push the
wiring inside the cavity of the bridge.
6
Push down
to engage
9
Clip one end-cap at the beginning
of the row and one at the end
(provided in the starter kits).