Weidmüller PrintJet Mode D'emploi page 8

M-Print settings
Launch M-Print: Click > Start > Programs > M-Print or click the M-Print shortcut.
To view the zero reference point value, click File > Print > Settings.
If necessary, you can alter the zero point settings.
Default values for margins:
The values given are intended as a guide only. They vary according to the operating system used. It is necessary to carry out adjustments to
the settings for the margins and scaling.
Setting the zero reference point
Changes made to the zero reference point are applied to all MultiCard types. Use the configurations editor if you wish to adapt
the values of a MultiCard. Use the Help system in M-Print for assistance.
The graphic displays a MultiCard frame with 5 strips.
All manuals and user guides at all-guides.com
Select the printer driver EPSON Stylus C 62
Click accept, and then click Cancel to close the other open window.
Ensure that the PrintJet is connected to your PC and turned on.
Double-click a strip to select the MultiCards.
Carry out fine adjustments using the MultiCard DEK 5/5 included.
Select the type DEK 5/5 from the list and then click OK to confirm your
choice.
Your selection is displayed in the MultiCard frame. Double-click to
launch DEK 5/5. Mark these with the letter X (see example below), and
then print these out.
7