Publicité
Les langues disponibles
Les langues disponibles
DAILY ALARM SETTING
In Date alarm mode, PRESS the MODE button and enter daily
alarm mode. "DAILY" will appear in the top row.
Hourly chime and daily alarm can be turned on or off in this mode.
If the Nixon icon is shown, the daily alarm is on, and yep, it's off
when it's not shown.
The same is true the chime (bell) icon. Press
LAP/RESET
to
switch between Daily alarm and Chime on/off.
ALARM
daily alarm on
chime on
To set the daily alarm, press and hold, SET/SELECT for 2 seconds.
Set the hour and minute using the same technique as in Real Time
setting above. (LAP/RESET to increase and SET/SELECT to move
to next item to set).
PRESS MODE to lock in your information.
Note, when daily alarm goes off, the Nixon icon will blink.
All manuals and user guides at all-guides.com
DAILY ALARM SETTING, CHRONOGRAPH MODE
CHRONOGRAPH MODE
While in Alarm mode, PRESS MODE to enter Chronograph mode.
PRESS START/STOP to start and stop the chrono.
For Lap memory, press
LAP/RESET
while the chrono is running,
this will show the first lap time. Press
LAP/RESET
again to
restart chrono.
CHRO
PRESS
LAP/RESET
again to show the second lap, and so on up to
10 laps. Total lap times will equal total count time.
To recall the lap times, press SET/SELECT to view the laps.
You can only recall laps if the chrono is stopped.
To clear chrono, press START/STOP and then LAP/RESET.
TIMER SETTING
While in Chrono mode, press
MODE
to enter Timer mode.
"TIMER"
is shown in the top row.
TMR
PRESS START/STOP to stop or start the countdown timer.
PRESS LAP/RESET to select the quick preset timers:
1,3,5,10,15,30,45 minutes.To set your own Timer (time),
press and hold SET/SELECT for two seconds and set the
Timer time using the same technique as in Real Time mode
(LAP/RESET to increase and SET/SELECT to move to next
item to set).
PRESS MODE to lock in your information.
TIMER SETTING, ZONE MODE
ZONE MODE: SNOWBOARD BASE ELEVATION
This Mode has 160 Worldwide pre-preprogrammed snowboard
base elevations for instant altimeter calibration.
While in Timer mode, press
MODE
to enter Zone mode.
"Zone"
appear at the top.
ALTI
PRESS SET/SELECT to select the Zone (USA WEST) appears first.
PRESS LAP/RESET to forward to the next zone: USA EAST,
CANADA, EUROPE, JAPAN, and WORLD.
PRESS LAP/RESET to go forward in the zones and START/STOP to
go backwards. To drill down into a specific zone, press
SET/SELECT
while that zone is shown at the top. For example, in the WEST USA
zone, press
LAP/RESET
until location
9
is at the top. This is Squaw
Valley in California.
"Squaw"
and
2158 M
(the base elevation) scroll
across the screen.
see base elevation
chart at end of manual
for all resorts
ALTI
will
Publicité
