Publicité
Les langues disponibles
Les langues disponibles
Connectors (elysia qube)
Audio inputs
(XLR and ¼" phone jack)
Audio outputs
(XLR and ¼" phone jack)
Power switch
Please note that in stereo operation
both channels are always processed by
one single control voltage generated
from a mix of both signals. This means
you should only compress adequate
stereo material like sum signals in this
mode - dissimilar signals like a bass
drum in one channel and a synth pad in
the other will not give you the intended
'dual mono' results.
Mono operation: Connect either input and output 1 or 2 - both will work
identically.
Stereo operation: Connect both inputs and outputs 1 and 2 - the choice
which channel is left and which is right is up to you.
Inputs (+4 dBu)
XLR balanced:
Pin 1: ground
XLR unbalanced:
Pin 1: ground
Jack balanced:
Sleeve: ground Tip: hot (+)
Jack unbalanced:
Sleeve: ground Tip: hot (+)
Outputs (+4 dBu)
XLR balanced:
Pin 1: ground
XLR unbalanced:
Pin 1: ground
Jack balanced:
Sleeve: ground Tip: hot (+)
Jack unbalanced:
Sleeve: ground Tip: hot (+)
6
IN 2
IN 1
IN 2
IN 1
Attention!
There may be 48V!
OUT 2
OUT 1
OUT 2
OUT 1
Power
+ 16 Volt
- 16 Volt
18V/1A DC
elysia GmbH | Am Panneschopp 18 | 41334 Nettetal | Germany
Pin 2: hot (+) Pin 3: cold (-)
Pin 2: hot (+) Pin 3: ground
Ring: cold (-)
Ring: ground
Pin 2: hot (+) Pin 3: ground
Pin 2: hot (+) Pin 3: idle
Ring: ground
Ring: idle
Precautions
WARNING: High Voltage
• Make sure to operate your API 500 series compatible rack at the specific
mains voltage of your country.
• Replace rack frame fuse with the same type and value only.
• Your rack frame must be connected to ground.
• Do not use a damaged power cord.
• Never place containers with liquid on the rack.
• Do not expose this device to rain or moisture.
• Do not use this device near water.
• Refer service to qualified service staff only.
CAUTION: Temperature
• Surfaces of the device may become hot during operation.
• Do not install this device near any heat source such as radiators, stoves
or other heat sources.
CAUTION: Connecting & Mounting
•
Never connect to the output of a power amplifier.
• Do not apply extensive force when installing this device.
• Use the device according to this manual only.
CAUTION: Humidity
• If this device is moved from a cold place to a warm room, condensation
can occur inside the device. To avoid damaging the unit please allow it
to reach room temperature before switching it on.
7
Publicité
