Pettec Remote Spray Trainer 3.0 Mode D'emploi page 22

Filling the training collar
The PetTec Remote Spray Trainer 3.0 must be
turned off before filling with spray. Place the
filling spout positioned vertically on the fil-
15 Sec.
ling valve. When the filling spout is positioned
correctly, fill the trainer by pressing it down
lightly for 15 seconds.
Note: To completely empty the tank of the
PetTec Remote Spray Trainer 3.0, press down
lightly on the filling valve with a screwdriver.
Attaching the collar
The collar must be properly secured so that the spray signal will be effective.
You can test for a proper fit by ensuring that you can fit one or two fingers
beneath the collar. The optimal position of the PetTec Remote Spray Trainer 3.0
is directly under the dog's nose.
Be careful that the collar is not too tight, but don't allow it to slip; otherwise the
spray signal will not be effective.
22