Pettec Remote Spray Trainer 3.0 Mode D'emploi page 21

Setting up the remote control
•
Unpack the included micro-cell batteries.
•
Then, open the remote control's battery
compartment and install the batteries. Be
careful to close the cover properly.
•
Note: The included batteries are not
rechargeable, but we recommend using
rechargeable micro-cell batteries.
•
Fully charge the trainer using the char-
ging cable, until the status LED on the
training collar glows green continuous-
ly. If the status LED is not glowing green
continuously, it is not fully charged.
•
Open the rubberized cover on the under-
side of the training collar, and insert the
charging plug into the opening.
•
Next, connect the USB port to a standard
USB power plug and plug it into a power
outlet. A full charge takes about 2 hours.
21