Publicité
Les langues disponibles
Les langues disponibles
us_main.book.book Page 52 Wednesday, June 29, 2022 8:57 AM
52 TROUBLESHOOTING
Problem
Dishwasher operates
Dishwasher is connected to cold water.
too long.
• Check the water supply connection or water heater setting. (Heating cold water takes
Water remains in tub
Drain hose is kinked or clogged.
after completion of
• Adjust hose or clear blockage.
cycle.
Noise
Some level of noise is normal during operation.
• Detergent cover opening.
• Drain pump at the beginning of drain cycle.
The dishwasher is not level.
• Adjust leveling feet.
Nozzle arm knocking against dishes.
• Reposition the dishes.
Lights do not
Power is not connected.
illuminate.
• Connect power supply.
Spray arms do not
Holes of spray arms are blocked by food particles.
rotate smoothly.
• Clean the holes of spray arms.
Upper rack is
Rack is poorly adjusted.
crooked.
• See the Height Adjustable Upper Rack section.
Dishwasher
This is a safety measure. Contact with escaping steam or the hot contents of the
continuously chimes
dishwasher could result in injury.
when the door is
• Close the door until the dishwasher and dishes have cooled down. The chiming will stop if
opened, during or
right after a cycle
has completed.
Door does not close
Cutlery rack is not properly loaded.
completely. (For
• Push the door handle to close the door properly until it clicks.
models with cutlery
rack)
Dishwasher chimes if
Bumping into or touching the control panel during operation may result in a disabled
panel is touched
button sound. Only the Power, Start, Control Lock and Remote Start buttons are
during operation.
enabled during operation to prevent cycle settings from being changed inadvertently.
• Button sounds can be turned off by using Option Setting Mode. Refer to the Using the
• The end of cycle chime and safety alert sounds will still sound.
Dishwasher did not
Door was opened during cycle.
finish cycle.
• If the door is opened during a cycle, the Start key must be pressed within 4 minutes or the
Leaking in front of
Dishwasher not leveled properly.
appliance
• Verify the appliance is level from side to side and from front to back. See leveling
Wrong detergent used.
• If excessive sudsing is causing the leak, allow the foam to subside for 24 hours then clean
longer.)
the door is closed or the interior temperature has cooled.
Option Setting Mode topic.
machine turns off and all settings are lost.
instructions in the Installation section.
the inside of the tub with milk.
Possible Cause & Solution
Publicité
