Publicité
Les langues disponibles
Les langues disponibles
PRODUCT ASSEMBLY
BASE ASSEMBLY
•
Put the round base on the flat ground
•
There are 3 screws labeled on the base plate, take them out
before assembled.
•
Put the whole body into the base plate
•
Fasten the screws on the bottom of base plate. Do not
over-tighten the screws.
HOW TO ASSEMBLE THE FAN
•
Remove the locking nut and blade cap from the motor
spindle (Fig.1)
•
Place the rear guard into position. If this is done correctly, the
carry handle will be at the top (Fig.2),
•
Fix the rear guard into position by replacing the locking nut
tightly by hand (Fig. 3). Do not force the locking nut.
•
Press the fan blade (Fig.4) and locking the blade cap by
turning it anti-clockwise.
5
Publicité
