Abilia Andromeda Socket DK Mode D'emploi page 14

4.2 Control with Radio transmitter
4.2.1 Radio transmitter (Z-Wave)
Example: To turn a lamp on and off every other time you press the button on the Z-wave
transmitter.
When controlling with radio you can only have the On/Off function (bistable function).
Andromeda Socket can be included and operated in any Z-Wave network with other
Z-Wave certified devices from other manufacturers and/or other applications. All non-battery
operated nodes within the network will act as repeaters regardless of vendor to increase
reliability of the network.
4.2.2 Z-Wave network functions
Add (Include):
1. Put the system controller (Z-Wave transmitter) into inclusion mode (Include) by following
the instructions provided by the controller manufacturer.
2. Press the On/Off button on Andromeda Socket three times within 1.5 seconds.
Remove (Exclude):
1. Put the system controller (Z-Wave transmitter) into exclusion mode (Exclude) by
following the instructions provided by the controller manufacturer.
2. Press the On/Off button on Andromeda Socket three times within 1.5 seconds.
Reset (Reset):
1. Press and hold the On/Off button on Andromeda Socket for approx. 6 seconds until the
indication light glows steadily.
2. Release the On/Off button on and press ones again within 3 seconds.
Note! Use this procedure only in the event that the system controller (Z-Wave transmitter) is
missing or otherwise inoperable.
Associating Andromeda Socket in a Z-Wave Network (Associate):
The Andromeda Socket supports the Association Group 1 (Lifeline) and up to 5 devices can
be added to this group. Association process only works after the device has been included
to a Z-Wave network.
1. Put the controller into Association mode. Some controllers can automatically associate.
See the controller manufacturer manual.
2. Identify Andromeda Socket to the controller by sending the node information, do this by
pressing the On/Off button three times within 1.5 seconds.
3. The controller should confirm association when the process is successfully completed.
See the controller manufacturer manual for more information.
14