Abilia Andromeda Socket DK Mode D'emploi page 12

2. Product Overview
Andromeda Socket consists of the following parts:
419881 Andromeda Socket UK
1. 230V socket. For connection of
the device to be controlled.
2. Detector eye. Receives IR signal.
3. Indication light.
3. Connection
1. Make sure that the device to be connected, that has its own power switch is set to "on".
This is easiest done by connecting to a wall socket and ensure that the device is on (for
example a lamp should be lit).
2. Connect the Andromeda Socket to a wall socket.
3. Connect the device to be controlled to the socket on the relay unit (1).
4. Make sure that the device gets power by pressing the On/Off button (4).
5. If IR is used, keep in mind that the range will be reduced if the detector eye (2) is
covered or hidden in some way, for example by curtains or furniture.
6. Program the relay unit by following the instructions in the next chapter.
The Andromeda Socket comes factory set with GewaLink channel 16 and bistable function.
The relay unit does not need to be programmed if it is the function and channel to be used
on the IR transmitter.
5
4
3
2
1
4. On/Off button. For programming and to
manually turn On/Off the power.
5. 3.5 mm jack. For connecting an external
control switch or external detector eye.
12