Publicité
Les langues disponibles
Les langues disponibles
Door Handle, Door Trim
and
Door
Removal
Instructions
(continued)
Refrigerator Door
6. To remove refrigerator door trim and
handle: This model has a medium length trim
piece which continues from the bottom of the
handle to approximately five inches down. The top
of the trim attaches to the handle bracket. An
adhesive "trim lock" is positioned about one half
inch down from the bottom of the handle. The
bottom of the trim is held in place by either an
adhesive trim lock, or a trim lock with two prongs
inserted into a hole on the face of the door.
Remove the trim by gently pulling the trim lock
areas out and away from the door. When the trim
is free from the door, slide the trim straight down
and away from the handle bracket.
For models with short handle trim, remove by
sliding the trim straight down and off of handle
bracket.
To remove handles: Remove the three screws
attaching the handle to the refrigerator door.
To reattach trim: Slide both trim locks out of trim.
Insert the new adhesive trim locks contained in
your literature pack.
NOTE: Trim locks must be removed and installed
by sliding OVER the two donut shaped areas. Install
trim to handle by sliding up over bottom of handle.
Carefully align trim and press down at trim lock
locations. Use rubbing alcohol to remove any
adhesive residue from old trim lock location(s).
For models with short handle trim, slide the trim
straight up onto handle bracket.
Washer
7. To reinstall refrigerator door:
Bolt lower hinge to cabinet. Install
washer on the lower hinge pin.
Replace toe grille by pushing straight
on.
8. Install center hinge and secure to
cabinet as shown, using the screws you
saved earlier. Install refrigerator door
on lower hinge pin. Align door with
edge of cabinet. Hold the door on front
of cabinet.
9. To reinstall freezer door: Place
original washer over hole in
refrigerator door and line up hole in
center hinge. Insert hinge pin through
both holes. Place washer on hinge pin,
then position freezer door on center
hinge.
10
Hinge
Bolt
10. Assemble upper hinge to top of
cabinet and door. Do not completely
tighten screws.
Check door alignment. Space
between door and cabinet should be
3/4" at top hinge, the width of an
ordinary penny.
Return food, bottles, and other articles
to doors. Additional adjustment may
be necessary after loading the door
shelves. Turn the refrigerator
control on and to the previous
setting.
Publicité
