Publicité
Les langues disponibles
Les langues disponibles
5. Surface for acupuncture massage
6. Removable rollers for the base of the appliance
7. Non slip feet
8. Maximum water filling mark «MAX»
BEFORE USE
Remove all packing materials from the de-
vice.
OPERATING
INSTRUCTIONS
1. Place the appliance on a level horizontal sur-
face in front of a comfortable seat (chair).
2. Fill the massager with water, which has a
comfortable temperature, up to the maximum
level (8). To enhance the positive effect of mas-
sage, you may add some bath salt or oil.
3. Plug the appliance into a wall outlet.
4. Sit down and place your feet into the foot bath. Always
remain seated when placing your feet into the bath
or removing them.
5. Set the operating mode switch (3) to a desirable position.
6. To massage and make pedicure of your soles, you may use the
detachable massage attachments in the center (4). To make
the attachments rotating press them with your foot (see the
picture at page 2). Brush (4.1) can be used to stimulate the
reflex centers in the sole. Massage wheel (4.2) provides
gentle massage. Callus remover (4.3) removes the dead skin
on feet. Select an attachment and place it into the special
recess on the front face of the appliance. Please, note that the
attachments can be installed one way only.
7. After finishing the massaging procedures set the switch (3) to
the «0» position and follow the instructions in the «Care and
cleaning» section.
Description of operational modes
1) Vibromassage
Vibromassage releases muscular tension and improves blood
circulation. This feature can be used with or without water in the
device.
Note: vibromassage duration should not exceed 10 minutes
without water and 20 minutes with water.
Appliance usage
6
Publicité
