Uline H-10316 Instructions De Montage page 2

NOTE: Place all laminate panels on a clean,
smooth surface to prevent scratches.
NOTE: Count and inspect all pieces before
disposing of any carton or packing materials.
If using add-on dividers, the starter divider
must be assembled first. The add-on dividers
can then be assembled and connected to the
starter divider. See page 5 for add-on assembly.
1. Insert four bolts through underside of steel foot and
attach to post. Tighten using Allen wrench. Repeat
for other steel foot and post. (See Figure 1)
Figure 1
Post
Steel Foot
Bolts (A)
PAGE 2 OF 15
STARTER DIVIDER ASSEMBLY
2. Using two people, stand posts upright. Place
horizontal bar between posts. Insert lock on end of
horizontal bar into channel on post. Tighten locks
using Allen wrench. Repeat for opposite end.
(See Figure 2)
NOTE: Steel feet should be facing inward for
improved stability.
NOTE: Locks are built into the ends of the
horizontal and vertical bars. Locks will require
approximately a 1/2 turn in order to engage
the lock and connect bars and posts.
Figure 2
Lock
Horizontal
Bar
Post with
Steel Foot
1122 IH-10316