Publicité
Package contents
1. Radiator / Tubes / Pump
2. Fans
3. CPU adapter
4. AMD corner fixing brackets
5. Intel corner fixing brackets
6. AM4 corner fixing brackets
7. AM4 hooks
AMD mounting hole
Intel mounting hole
1
Depending on your Intel CPU, place the 4 corner screws (10) in the corresponding hole of the CPU
adapter (3), Be careful of the direction! Then install the adapter on the back of your motherboard.
Depending on your Intel processor, please use the corresponding corner brackets (5). Then fix the corner
brackets on the pump using the screws (13)
2
Apply the thermal paste (8) evenly to the CPU. Then remove the protective film Attention do not forget
this step as this may damage your installation!
Position the pump on your CPU previously coated with thermal paste. Then fix the spring / pressure
3
screws (9). Start by adjusting the screws then tighten the screw A, the screw C, then B and finally D.
AMD mounting hole
According to your AMD CPU, place the 4 corner screws (10) in the corresponding hole of the CPU
adapter (3), Attention to the direction! Then install the adapter on the back of your motherboard.
1
Depending on your AMD processor, please use the corresponding corner brackets (5). Then fix the
corner brackets on the pump using the screws (13)
Apply the thermal paste (8) evenly to the CPU. Then remove the protective film.
2
Be careful do not forget this step as this may damage your installation!
Position the pump on your CPU previously coated with thermal paste. Then fix the spring / pressure
3
screws (9). Start by adjusting the screws then tighten the screw A, the screw C, then B and finally D.
Depending on your AM AM4 processor, please use the corresponding hooks (7). Then fix the hooks on
1
the pump using the screws (13)
3
After performing step 7, position the pump on your CPU previously coated with thermal paste. Then fix
the spring / pressure screws (9)
Fasten the fan (s) to the radiator with the fixing screws (11). Then fix the radiator to the chassis using the
fixing screws (12)
4
Finally, connect the power supply to the pump to your motherboard. Then power the fans. Note: At
startup you may hear a slight noise while you start the pump.
06
All manuals and user guides at all-guides.com
8. Thermal paste
9. Spring / pressure screw
10. Corner fixing screw
11. Fastening screws for Fans
12. Fastening screws for Radiator
13. Fastening screws for Pump
INTEL CPU
AMD CPU
AM4
UNIVERSEL
Publicité
