Sublue WhiteShark Tini Manuel De L'utilisateur page 13

3. When the equipment is powered on, if the indicators indicates a low battery
power, it indicates that the battery power is low. Please charge it in time.
4. It will take about 2 hours to fully charge the battery.
2
Battery Charging
Connect the charger to the AC mains supply (100-240VAC, 50/60Hz).
Socket Adapter
When you charge the battery, please
make sure the positive and negative
signs of the battery should be in the
same direction as those of the charging
block to avoid mis-insertion.
17
Battery and Charging Base
3 Battery Replacement
When the battery is installed and tightened in the correct way, you will hear a sound of
"clatter". Please confirm that the battery is already installed tightly (as shown below).
Open the battery
compartment cover
4 Introduction to the Battery of Control Handle
The control handle cantains a built-in lithium polymer battery with a capacity of 1150mAh,
which can meet the needs of the control handle service time.
5 Charging of Control Handle
The control handle is embedded with a magnetic charging connector, which can be
charged with Sublue magnetic cable. .
咔嗒
Insert the battery into the compartment
downward, and press
the battery after the hook is hung
18