Geba Tronic Cody Universal 1/1 Mode D'emploi page 24

Keypad
Before programming your Cody Universal with your personal codes, please check the faultless function
of the appliance with the help of the factory's pass code 1234 and the
Usually, any programming is made via your personal mastercode. In order to get familiar with that kind
of programming, you start with the input of a new pass code, which replaces the one preset by the
factory (1234). The procedure is explained under item "Program 2".
After that please change the factory set mastercode to your personal code of choice.
Attention / Note
In case you made a mistake on programming, you can start over again by pushing of the
button
Program 1
Input of a new mastercode
Factory setting = 1-8
Enter 8 digit
mastercode
Enter 8 digit
NEW
mastercode
All manuals and user guides at all-guides.com
Programming
instructions
Please read first - then do programming!!!
Sound signal
push
2x long
button
push
button
The new mastercode is now saved!
push
button
Sound signal
1x long
button.