HAMPTON BAY GTP1613AL Manuel D'instructions page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
2ea Washers (#2)
2ea Outlet Box Screws (#16)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#17) into the Cross Bar (#15). Mount the Cross Bar
(#15) to the Outlet Box (#13) using the two Outlet Box Screws (#16). [Make sure the
threads of the Mounting Screws (#17) are facing outside when the Cross Bar (#15) is
attached to the Outlet Box (#13).]
2. Wrap the ground wire from the fixture around the Ground Screw (#18) on the Cross Bar
(#15), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#13). Connect the white wire from the fixture to the white wire (neutral
wire) from the Outlet Box (#13). Connect the black wire from the fixture to the black
wire (live wire) from the Outlet Box (#13). Cover the three connections using the three
Wire Connectors (#14). Wrap the three wire connections with electrical tape for a more
secure connection. Position the wires back inside the Outlet Box (#13). Note: If you
have electrical questions, consult your local electrical code for approved grounding
methods.
3. Place the fixture body to the wall by aligning the protruding Mounting Screws (#17)
through the appropriate holes on the Wall Plate (#1). Place the two Washers (#2) over
the two protruding Mounting Screws (#17). Tighten the fixture to the wall by screwing
the two Lock Nuts (#3) onto the two protruding Mounting Screws (#17).
4. Once the fixture is mounted on the wall, caulk the space between the wall and the upper
3/4 area of the Wall Plate (#1) to prevent water seeping into the Outlet Box (#13). Leave
the bottom 1/4 area uncaulked for drainage of any water which might leak into the
enclosure.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
2ea Lock Nuts (#3)
2ea Mounting Screws (#17)
3ea Wire Connectors (#14) 1ea Cross Bar (#15)
1ea Ground Screw (#18)