LiftMaster K77-38018 Mode D'emploi

CARTON INVENTORY
Solenoid Lock Harness . . . . . . . . . . . . . . . . . . . . . . . . . . 94-37518
Control Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .001D8052-1CC
INSTALLATION
1. Disconnect power to the operator.
2. Remove RED/BLACK wires connected to -/+ battery terminals
3. Connect solenoid lock harness following illustration below.
4. After solenoid lock harness is installed, reconnect power and
test for proper operation.
SOLENOID LOCK
12 VDC SOLENOID CONNECTION
TO J8 PLUG ON
CONTROL BOARD
Red
Black
CONTROL BOARD
Red
Black
20A
Red
Battery
12V 7AH
Black
Battery
Piggyback
12V 7AH
wires
SOLENOID LOCK HARNESS KIT
FOR MODELS LA400VDC, LA412VDC, LA500VDC
To reduce the risk of SEVERE INJURY or DEATH:
• ANY maintenance to the operator or in the area near the
operator MUST NOT be performed until disconnecting the
electrical power (AC or solar and battery) and locking-out
the power via the operator power switch. Upon completion
of maintenance the area MUST be cleared and secured, at
that time the unit may be returned to service.
• ALL electrical connections MUST be made by a qualified
individual.
Red
Red
24 VDC SOLENOID CONNECTION
TO J8 PLUG ON
CONTROL BOARD
1
K77-38018
Red
TO BATTERY
Black
SOLENOID
LOCK
HARNESS
Piggyback
wires
Red
Battery
12V 7AH
Battery
Piggyback
wires
12V 7AH
Black