ulsonix TOPCLEAN 1800PRO+ Manuel D'utilisation page 30

9 - Engine
10 - Wheel
11 - Hard bristle brush
12 - Brush with soft bristles
13 - Holder pad
3.2. Preparation for operation
1) Installation of the control lever
Place the base of the control handle on the back of the device body. Align the screw
holes of both parts. Screw the used parts together with the countersunk head screws.
A - Countersunk cross-head screws
B - Base of the control handle
C - The body of the device
2) Installation of the tank
a) Place the tank on the control handle tube.
b) Use two clamps to attach the tank to the tube of the control handle. Then
install the hole plate and tighten the nuts on the threads of the clamping
bracket.
c) Connect the water pipe to the water outlet connector.