Diagnostic Messages - Teuco HYDROLINE Hydrosilence T50 Manuel De L'utilisateur

EN

DIAGNOSTIC MESSAGES

NO WATER IN THE HYDROMASSAGE
The hydromassage does not start, the HYDRO
key flashes at low frequency between off and
high intensity.
After 30 minutes the display returns to standby.
Add water to the tub.
LACK OF LIQUID AT THE 1ST AND 2ND
SANITISING LIQUID LEVEL
The hydromassage
SANIFICATION key flashes at low frequency
between low intensity and high intensity.
After 20 seconds, the SANIFICATION key returns
to the high intensity illumination status.
Add sanitising liquid.
LACK OF
SUCCESSIVE SANITISING LIQUID LEVEL
The hydromassage
SANIFICATION key flashes at high frequency
between low intensity and high intensity.
After 5 minutes, the panel returns to standby.
Pressing the HYDRO or SANIFICATION key, the
panel returns to standby.
Add sanitising liquid.
NO WATER IN THE HYDROMASSAGE WHEN
SANITISING
The sanification stops or does not start,
the SANIFICATION key is illuminated at high
intensity, the HYDRO key flashes at low
frequency between off and high intensity.
After 3 minutes, the panel returns to standby.
Add water to the tub.
In case of breakdown or incorrect operation (e.g., anomaly in the pump, control unit, power, unit ...)
contact your nearest Teuco authorised assistance centre (see list of Teuco authorised assistance
centres). The manufacturer cannot be held responsible for damage caused by appliances that
have been improperly tampered with.
16
starts, but
LIQUID AT THE 3rd
does not start,
the
AND
the
HYDROLINE